Editor's Note: This article was orginally published May 1, 2011. Some of the information may no longer be relevant, so please use it at your discretion. I recommend reading the up in the forscan threads. What are you trying to do that you need to open the an file in ForScan. Programming Ford electronic control units (ECUs) is pretty straightforward and simple compared to many other OEMs. you can copy/paste the data from your AsBuilt while viewing in your browser. However, Ford does do one thing differently than most other OEMs. The normal Ford programming procedure has you "inhale" (read and store data) the As-Built data (from the old ECU to the scan tool), so As-Built vehicle specific production and calibration details can then be transferred to a new, remanufactured, or salvaged ECU you are installing.Ī complication arises when you are attempting to replace an ECU that is dead or not communicating with the scan tool (or programming device). Then scroll down to the middle of the page and select 'Module Build Data (As Built)'. ![]() ![]() The Ford recommended procedure for this is stated as: In this instance, you are going to have to use a different method of telling the replacement ECU what the needed As-Built data information should be. Go to and select 'Quick Guides' from the left column. "Programmable Module Installation (PMI) must be performed when replacing module.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |